ORD Bots on Sale at Inventables.com

Inventables is now taking pre-orders for Hadron ORD Bots.  I will not be shipping anymore kits and Inventables  is now the official, authorized distributor of the kits.  Go here to get on the list for one of the units.  The Inventables kits will also have the following improvements.

Bright Dipped Finish

  The previous version looked great, but the matt finish quickly gets dirty and scuffs often looked like sceatches.  Bright dipping is a chemical polishing that is done before the anodizing process.  The goal is to get the finish quality of a Mag Light.

Open Ended Wiring Holes.

A well wired ORD Bot is a thing of beauty, but once wired some of the parts are trapped by the wiring.

By adding open ended wiring holes, the wires can escape out the sides.  This will allow you to completely side off thing like the gantry without removing any connectors.

Wider Extruder Platform.

Deep extruders like some of the Wade’s family of extruders previously had to overhang the front a bit.  This adds more depth and an extra hole pattern to give you more options.

Loop Belts

With loop belts you will not have to measure and cut from open ended stock.  They will be a lot easier to install and will have twice the grab in the belt clamps.

Build Platform Changes.

  • Added holes for the ORD Bot heated build platform.
  • Increased spacing between the wheels.  This improves rigidity, reduces the sensitivity and cleans up the busy center area where the clamp and switches. fit.

Electronics Plate Changes

The Electronics plate will now have hole patterns for the RAMPS, ORDuino and Azteez controllers.
Share and Enjoy:
  • Print
  • Digg
  • StumbleUpon
  • del.icio.us
  • Facebook
  • Yahoo! Buzz
  • Twitter
  • Google Bookmarks

Comments are currently closed.