How can I fix the honeycomb to the table frame?

Extrusions/Tubing/Hinges/Etc.

How can I fix the honeycomb to the table frame?

Postby Ischcuch » Sat Jun 29, 2013 12:47 am

I will use 20mm thick expanded Ali honeycomb inside the material support frame. The honeycomb is very thin and flimsy. It will be placed on cross members spaced at 100mm intervals that are fixed to the bottom of the frame.

I would appreciate any advice on how to fix the honeycomb to the edges of the frame.
Ischcuch
 
Posts: 26
Joined: Tue Apr 02, 2013 12:15 am

Re: How can I fix the honeycomb to the table frame?

Postby TLHarrell » Mon Jul 01, 2013 5:20 pm

Usually the edge of the frame would be a C-channel sized so the honeycomb slots into it. If using an L-channel instead you may consider epoxy or wire.
40w Full Spectrum Engineering 5th Gen Hobby 20"x12" w/ Rotary Engraver
South San Francisco Bay Area - Sales and Support Representative for Full Spectrum Engineering
408-47-LASER - Skype: whitelightlaser-thomas - Facebook: White Light Laser
TLHarrell
 
Posts: 419
Joined: Thu Jul 28, 2011 11:30 pm
Location: Morgan Hill, CA


Return to Enclosures/Framing Etc.

Who is online

Users browsing this forum: No registered users and 2 guests