orcinus wrote:Just a quick note:
According to Repetier's author, the SDA and SCL on the X3 are marked the wrong way around.
I'm not sure if that's for the original version, 1.1 or both.
In any case, if you can't get anything to show up on the ViKi, try swapping them around.
If you still can't get anything, try shorter cables.
orcinus wrote:There's a merge request that should enable all ViKi features on Repetier apart from the SD card slot:
https://github.com/repetier/Repetier-Firmware/pull/87
orcinus wrote:Are you using the included cables or custom (shorter) ones?
orcinus wrote:The expansion shield?
Edit: Oh, you mean the 1.1 shield. (i've got the voltage boost one... haven't even checked out what's new with the 1.1 shield)
Return to 3D Printer General Discussion
Users browsing this forum: No registered users and 11 guests