X carriage begining to get a bit stiff (after nearly a year)

Questions, Suggestions, Tips, Etc

X carriage begining to get a bit stiff (after nearly a year)

Postby LeonS » Fri Mar 02, 2012 1:09 pm

My X carriage is noticeably stiffer than the Y axis movement. I think the bearings have gotten dirty due to fumes.

Is there something I can do to clean the bearings or should I just replace them?

If I replace them would it be best to upgrade to the two bearing per wheel revision. My wheels are the earlier single bearing wheels.

Thanks in advance,
Leon
LeonS
 
Posts: 145
Joined: Wed Nov 25, 2009 8:09 pm
Location: Herndon, VA

Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 7 guests

cron