First motion test (Video) Some questions too.
Posted: Thu Sep 26, 2013 6:42 pmSo I got everything wired up for testing. I am using the LO DSP with the LaserCAD software that came with it. This test was using the default settings from LaserCAD. The drivers are Keling KL-4042D's.
http://vimeo.com/75509470
It seems to run smooth and very quiet. Then I made some changes based on the reading I have been doing and now it's all over the place and noisy. My question is how do I go about optimizing the system for my components. Is there a logical method for the process? I have not found any documentation of a 2.x with the drivers I am using with the LO DSP. I can always reset the default but I am not sure that is optimal.
Thanks for any help you can provide!
http://vimeo.com/75509470
It seems to run smooth and very quiet. Then I made some changes based on the reading I have been doing and now it's all over the place and noisy. My question is how do I go about optimizing the system for my components. Is there a logical method for the process? I have not found any documentation of a 2.x with the drivers I am using with the LO DSP. I can always reset the default but I am not sure that is optimal.
Thanks for any help you can provide!