Front Interface Panel Plate Installation

Questions, Suggestions, Tips, Etc

Front Interface Panel Plate Installation

Postby techsavvy34 » Mon Jul 28, 2014 3:29 am

I was wondering if the Interface Panel Plate for the front is suppose to screw into the the aluminum extrusion? I have the B19011 rev.4 plate. There is two holes at the top and two holes at the bottom.
Do I screw it to the the top hole to the top extrusion and the bottom holes to the middle 2040 extrusion?
techsavvy34
 
Posts: 20
Joined: Sun May 18, 2014 9:52 pm

Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 2 guests