400X600 Honeycomb for stander 2.X

Questions, Suggestions, Tips, Etc

400X600 Honeycomb for stander 2.X

Postby JasonW » Thu Oct 30, 2014 4:14 am

Can any one help me measure if the stander 2.X will accept this Honeycomb from lightobject?
http://www.lightobject.com/400X600-Hone ... -P706.aspx
X axis seem to be fine, Y is pretty close to the limit though.

Thanks!
JasonW
 
Posts: 5
Joined: Mon Sep 29, 2014 5:31 pm

Re: 400X600 Honeycomb for stander 2.X

Postby sshwarts » Thu Oct 30, 2014 6:15 pm

I can't answer your question directly, but on my build (which is an over-sized) I bought a large one and cut it down. It's put together with strips of corrugated steel which then has rods put through it and nuts attached. To cut it down, I removed the aluminum frame, pulled the rods back to the point I could remove strips to get my length. Then I cut it down with shears to get my width. Finally I removed each rod, cut it, and then using my die set, rethreaded the end and put the nut back on. A Lot of work, but makes for a nice bed. Being steel it also means I can use magnets to hold down warped or light materials.

Scott
sshwarts
 
Posts: 93
Joined: Tue Apr 22, 2014 6:37 pm

Re: 400X600 Honeycomb for stander 2.X

Postby JasonW » Fri Oct 31, 2014 7:41 am

Thanks Scott! Being able to modify it is all I need to know :D
JasonW
 
Posts: 5
Joined: Mon Sep 29, 2014 5:31 pm


Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 3 guests