Page 1 of 1

400X600 Honeycomb for stander 2.X

PostPosted: Thu Oct 30, 2014 4:14 am
by JasonW
Can any one help me measure if the stander 2.X will accept this Honeycomb from lightobject?
http://www.lightobject.com/400X600-Hone ... -P706.aspx
X axis seem to be fine, Y is pretty close to the limit though.

Thanks!

Re: 400X600 Honeycomb for stander 2.X

PostPosted: Thu Oct 30, 2014 6:15 pm
by sshwarts
I can't answer your question directly, but on my build (which is an over-sized) I bought a large one and cut it down. It's put together with strips of corrugated steel which then has rods put through it and nuts attached. To cut it down, I removed the aluminum frame, pulled the rods back to the point I could remove strips to get my length. Then I cut it down with shears to get my width. Finally I removed each rod, cut it, and then using my die set, rethreaded the end and put the nut back on. A Lot of work, but makes for a nice bed. Being steel it also means I can use magnets to hold down warped or light materials.

Scott

Re: 400X600 Honeycomb for stander 2.X

PostPosted: Fri Oct 31, 2014 7:41 am
by JasonW
Thanks Scott! Being able to modify it is all I need to know :D