Page 1 of 1

Drivers for stepper motor

PostPosted: Sun Mar 05, 2017 12:16 am
by Alpi
Hello there! I am thinking about purchasing for my laser 2.x the M542T drivers and AWC708C Lite DSP (my motors are Nema17 and bed size 30x60cm). From the rest of the blogs and forum I am sure about the Controller. However I have not seen these drivers mentioned here and to me looks like a nice option. Has anyone tried them before? any advice? Thanks! :D :D

Re: Drivers for stepper motor

PostPosted: Sun Mar 05, 2017 11:08 am
by terjeio
Should be ok, maybe a bit overkill for a laser engraver. I am using DM420A which is rated lower current-wise.