by LeonS » Mon Mar 21, 2011 1:18 pm
I see what you mean. I was thinking there might be enough clearance to center the 23 on the existing hole. It looks like moving the motor to closer to the body of the bracket would cause the 23 to interfere with the delrin bearings.
It's a pity that the 17s may delay our builds. Is there an existing 17 with a smaller shaft that would do the deed? If so we would just need to get the appropriate gears, or in the case of the Y drive, couplers that step up the shaft size to 1/4".
Cheers,
Leon