ShapeOko Getting Close
Posted: Wed Oct 12, 2011 1:02 am
Way to go Ed!
Check out this video of the ShapeOko router running on Makerslide. He has a lot of little details to clean up, but the goal of this project is to have a less than $300 router. This will eventually include everything including GRBL on Arduino, motors, drivers, spindle, etc. I have seen it in the flesh and it is really cool looking. He wants to put a handle on the side and you can carry it like a briefcase to the hackerspace and back.
The rapids are super fast and quite.
Blow it up to 480 res to see it better.
Check out this video of the ShapeOko router running on Makerslide. He has a lot of little details to clean up, but the goal of this project is to have a less than $300 router. This will eventually include everything including GRBL on Arduino, motors, drivers, spindle, etc. I have seen it in the flesh and it is really cool looking. He wants to put a handle on the side and you can carry it like a briefcase to the hackerspace and back.
The rapids are super fast and quite.
Blow it up to 480 res to see it better.