by pinoynyc » Sun Apr 20, 2014 1:51 pm
Hi,
Just got a awc608, created a simple vector drawing in lasercad (i.e: 6x6' square) , and set this layer to 200mm/s (to any speed).
but when for some reason, awc608 would only run at 70mm/s when performing the operation regardless of what speed I set in lasercad. I even switched it to engrave, and it didn't change anything.
I'm able to jog around using awc608 arrow keys and lasercad buttons at higher speed without any any, but only when I start engraving or cutting it slowed down to 70mm/sec
Thanks,
pinoynyc