orcinus wrote:Looking neat.
Have you considered switching to right-angle SMD LEDs?
Something like http://www.kingbright.com/manager/upload/pdf/KPA-3210SURCK(Ver1289175642.13) perhaps.
Improbable Construct wrote:Hey Frob,
Any word on ship dates for the Hadron build plates?
It's the last piece I need to get printing!
I am chomping at the bit to get up and running.
Thanks
Brandon
Improbable Construct wrote:Hey Frob,
Any word on ship dates for the Hadron build plates?
....
Brandon
frob wrote:...Sorry I got a little behind..... i discovered some minor functional impairments i am fixing for the production lot - so give me another week or so...
WhiteB0rd wrote:frob, can you clarify? Problems with the heated bed, or your controller board?
Does this mean you will be ordering the beds in a week, or shipping the beds in a week, or is the problem and delay with the controller?
Just trying to plan ahead, and wanting to get printing.....
When should I plan on the heated bed arriving at my door? WB
Users browsing this forum: No registered users and 24 guests