x belt grinds against idler flange [Solved]
Posted: Wed Apr 25, 2012 8:41 pm
Just finished the gantry and find that the x belt rides high on the idler and grinds against idler flange making some unnecessary noise. Is this normal?
The belt does not seem over tensioned. I've tried to slack it with the same result. It also makes no difference where the motor pulley is situated.
It's as if the flange part of the toothed belt clamp should be a bit higher?
Edit: Problem seems to have been solved.
The belt does not seem over tensioned. I've tried to slack it with the same result. It also makes no difference where the motor pulley is situated.
It's as if the flange part of the toothed belt clamp should be a bit higher?
Edit: Problem seems to have been solved.