flickerfly wrote:PLA? I've only done ABS so far so can't speak much to temp if that is the case. I've found a lot of the settings that I'd guess you need to adjust are is slic3r. I expect you'll need to play with the temperature for sticking to the bed and layer, but that could simply be the filament size. Make sure your slic3r filament size is correct as that will cause the somewhat feathery look I think I see. The default is 3mm and I've seen that get a few folks including myself until they get familiar with Slic3r's "Configure" button and the wonder therein.
Infill can actually not stick well because of too much heat. I've found a fan works well for me in those situations.
Users browsing this forum: No registered users and 27 guests