If the Prize was based on CNC Laser cost?

General discussion of laser machines

If the Prize was based on CNC Laser cost?

Postby stonycraft » Fri Mar 01, 2013 1:17 pm

Following on from my question about CNC Routers; comes the following:-
If someone (hyperthetical) were putting up a prize for the 'absolute' minimum build cost for a CNC Laser (Software, hardware, Jig etc) that can cut on a maximum base size 300x400 (12"x16") and board max 6-8mm (1/4"); what do you think it could be got down to?. I think for many people (as individuals) its a non starter unless they are guided along such a cost path.
Thoughts?
stonycraft
 
Posts: 48
Joined: Thu Feb 28, 2013 4:28 pm
Location: UK

Return to General

Who is online

Users browsing this forum: No registered users and 6 guests

cron