Page 2 of 2

Re: Looking for noob guidance on laser rastering (Ben's work

PostPosted: Mon Dec 17, 2012 9:19 pm
by shobley
Hi,

I still seem to be struggling a bit with the gantry configuration. Mine uses 2 motors to move the
gantry so the config is essentially:

X (Step pin 2, Dir pin 3)
Y1 (Step pin 4, Dir pin 5)
Y2 (Step pin 6, Dir pin 7)

All other pins are available.

It looks like the 2xlaser config files are for XYZW gantry configurations.

Is there anything I need to know when trying to use the 2xLaser configs with the XYY configuration?

Thanks,
Steve

Re: Looking for noob guidance on laser rastering (Ben's work

PostPosted: Wed Dec 19, 2012 12:58 am
by BenJackson
Z is fake and acts as a laser on/off so you can use almost any CAM program (with high Z feedrates and tiny cut depth) to make valid gcode without bandaids for switching the beam on/off.

W (or U when I did it originally) moves the table.

To get "YY" I think you want to look at gantrykins. I think the "right" way to do this involves dual home switches (so homing re-squares the gantry).

(btw I'm working on a 2.5 port right now. So far looking at other versions I think there is at least one small bug. I also fixed some issues with O145/M144 lately in my repo. After 2.5 works with parport I'm going to switch over to my 5i25 card)

Re: Looking for noob guidance on laser rastering (Ben's work

PostPosted: Wed Dec 19, 2012 1:33 am
by shobley
Thanks Ben - I'll certainly look into that with a view to squaring the gantry.

Right now (after much hardware tweaking) I've got the jitter down to 18000 - not too bad.

Steve

Re: Looking for noob guidance on laser rastering (Ben's work

PostPosted: Wed May 23, 2018 6:11 am
by JenniferT
just need help with the concepts, the fiddly bits are working themselves out.