Page 2 of 2

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Sat Apr 07, 2012 10:15 pm
by bdring
They are all gone now.

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Sun Apr 08, 2012 2:29 am
by Enraged
Bart, you may have your own source for the boards, but I have had good luck with Seeedstudio. My arduino shield was $35 for 10 boards with a custom color, and the turnaround time is less than a week from order to them shipping the boards out. Might be worth a look if there is a bunch of demand (especially given the 150 Shapeokos sold on Inventables).

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Thu Apr 19, 2012 11:46 pm
by T3PRanch
Anyone have a spare blank board or kit for sale?

Thurmond

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Thu Apr 19, 2012 11:58 pm
by bdring
I have 17 raw boards, but no time to kit or ship them for a couple weeks. Edward Ford is coming over tonight. I'll see if he wants to sell them.

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Fri Apr 20, 2012 2:20 am
by T3PRanch
bdring wrote:I have 17 raw boards, but no time to kit or ship them for a couple weeks. Edward Ford is coming over tonight. I'll see if he wants to sell them.


Thanks Bart, Let me know. PayPal ready! ;)

Thurmond

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Fri Apr 20, 2012 12:27 pm
by bdring
Edward has them all now. contact him

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Sun Apr 29, 2012 8:15 pm
by edward.ford
For anyone who is still looking for a stepper shield ,I have about 5 left. they are of the full kit variety (PCB + all components except pololu drivers) and cost $25 each. Shipping is included for domestic. If you're international, let me know and we'll figure something out.

If you're interested, send me an email edward @shapeoko dot com

-Edward

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Fri Nov 16, 2012 9:32 pm
by peterashuk
Hi

Thanks for posting the Gerber files, unfortunately, I can find a program to open the .art files.

I was hoping to print them out on my laser printer to make a prototype PCB.

I just need the top and bottom layers.

Peterashuk


bdring wrote:Here is the latest Gerber files and schematic. This rev was ordered a few days ago and is untested, but low risk.

Changes....

Now Stock GRBL pinout (XYZ)
Change 0.1uf Caps to smaller footprint
Configurable 4th axis.

Re: Arduino Stepper Shield Gerbers & Bill of Material Availa

PostPosted: Mon Dec 10, 2012 4:14 am
by ejs
I thought I should mention, Bart gave permission for these to be produced, and I've sold several dozen over at the ShapeOko forums and tindie. You can find the board at http://www.bit.ly/reactshop