AWC608 > which drivers? Cheap or big?
Posted: Thu Jan 01, 2015 5:44 pm
Hey : )
i am in the very beginning of my 2.x laser build but i always try to figure out everything as detailed as possible before i start. I think i will get an AWC608 / or an AWC 608 C. I am wondering which stepper drivers (for the recommendet NEMAS) are the best match. I read about the KL-4042D but they are pretty expensive so i would like to ask you, if they are really needed or if a cheaper solution would also work great. I only have expericen with small driver shields so i do not know about the benefits a better board would bring to the project.
thank you!
Andre
i am in the very beginning of my 2.x laser build but i always try to figure out everything as detailed as possible before i start. I think i will get an AWC608 / or an AWC 608 C. I am wondering which stepper drivers (for the recommendet NEMAS) are the best match. I read about the KL-4042D but they are pretty expensive so i would like to ask you, if they are really needed or if a cheaper solution would also work great. I only have expericen with small driver shields so i do not know about the benefits a better board would bring to the project.
thank you!
Andre