Reviews - BotFeeder 3D Filament

General discussion of 3D printers

Reviews - BotFeeder 3D Filament

Postby botfeeder » Sun Feb 23, 2014 8:46 pm

Thank you everyone for supporting BotFeeder & our recent success of the "Try Me Program" 50% discount.
Please leave us a feedback.

Learn more about BotFeeder 3D Filament
http://www.botfeeder.ca/abs-material/
To Order at BotFeeder Online Store

BotFeeder
http://www.botfeeder.ca/
User avatar
botfeeder
 
Posts: 18
Joined: Fri Nov 01, 2013 7:13 pm

Re: Reviews - BotFeeder 3D Filament

Postby 3dtech » Thu Jun 29, 2017 5:56 am

I'm not the reviewer type, mostly a lurker so this should be fairly short.

Daniel responded quickly to the coupon code request (3 minutes). I ordered on a Monday and received the filament (3.0mm Purple) in Florida on that Saturday.

It was my first time printing ABS (only printed with PLA before). The idler pulley and extruder body were literally the second and third prints following the mendel90 calibration block, albeit the calibration block took two tries since it didn't stick the first time to bare glass. A layer of Kapton tape did the trick (in the images I've moved on to try ABS juice).

The x ends and x carriage were next with no issues except I need to fine tune the retraction. Again, it shows my inexperience with ABS. 3d printing material gujarat

The filament measures 2.91 - 2.92 and is not oval. It also stays on the spool very nicely but comes off with no effort when feeding. I haven't went through enough to know what the end looks like.

Normally I print Ultimaker PLA at 170 and the bed at 70, the BotFeeder ABS seems to print best for me at 190 and bed at 110.

I've had a great experience with BotFeeder and their filament and would buy from them again.

I'd be happy to answer any questions or provide more information on my experience.
3dtech
 
Posts: 11
Joined: Tue Sep 08, 2015 6:21 am
Location: MONA TILES COMPOUND, NR. CHHANI CIRCLE, CHHANI ROAD, VADODARA - 390002. GUJARAT, INDIA.


Return to 3D Printer General Discussion

Who is online

Users browsing this forum: No registered users and 3 guests

cron