ramps 1.4 anyone using it for laser?

Discuss Laser CNC Software Issues

ramps 1.4 anyone using it for laser?

Postby jc286006 » Fri Dec 14, 2018 2:58 am

Hello everyone
are any of you running a laser with an arduino/ramps1.4?
if so i cant get my z bed to home had it homing then lost the sketch that was working.
I now have it moving again but it will not home any suggestions were i need to look in the marlin firmware to fix this issue?
thanks for any help James
jc286006
 
Posts: 2
Joined: Mon Dec 10, 2018 11:27 pm

Return to Software

Who is online

Users browsing this forum: No registered users and 0 guests