Page 1 of 1

Z Table Leveling? Any hints?

PostPosted: Wed Jun 03, 2015 8:04 am
by bloq
Hey all : )

my build is proceeding and i am so glad that there are people here, who are willing to help so much. I am going to install the z table very soon and i was wondering how you did the leveling for it. I tried to measure the distance from the bottom skin to the lift plates but due to the wobbling of the lift plates while the table frame is not attached i do not get the accuracy i would like to have. I am sure i can figure this out with lots of patience but i assume there are some better solutions around here ; )

thank you!
tm

Re: Z Table Leveling? Any hints?

PostPosted: Wed Jun 03, 2015 2:07 pm
by sshwarts
What I ended up doing was to cut a little acrylic piece (sort of a squared C shape) that fits between the bottom of the lift plate and the bottom rail. I then use that to get all four the same. What I ended up doing is to loosen the set screw on the pulley so I can turn the rod without messing up the others then tighten and up and move to the next. You're right, you need the bed in place to add some weight.

Scott

Re: Z Table Leveling? Any hints?

PostPosted: Thu Jun 04, 2015 7:47 am
by bloq
that sounds good : ) thank you!