MattyZee's mostly 2.x Laser Build
13 posts
• Page 2 of 2 • 1, 2
Re: MattyZee's mostly 2.x Laser Build
by diegocim » Fri Aug 03, 2012 2:20 pm
Hi, MattyZee
Your machine is looking great... I'm looking forward to start my own in few months, I'm sure I'll have the same problems with the frame, aluminium is quite expensive in Brazil.
Could you post the electric information that you decide to use? The pwm board, drivers and motors....
Thank you
Your machine is looking great... I'm looking forward to start my own in few months, I'm sure I'll have the same problems with the frame, aluminium is quite expensive in Brazil.
Could you post the electric information that you decide to use? The pwm board, drivers and motors....
Thank you
- diegocim
- Posts: 7
- Joined: Thu Jul 26, 2012 10:33 pm
Re: MattyZee's mostly 2.x Laser Build
by greenvandan » Sat Aug 04, 2012 1:20 pm
I'm really digging the aesthetic as well, particularly the slopes. Cant wait to see it with some skins on.
Edit: and the milled aluminum hardware!
Edit: and the milled aluminum hardware!
- greenvandan
- Posts: 59
- Joined: Mon May 28, 2012 1:41 am
- Location: Baltimore, MD
Re: MattyZee's mostly 2.x Laser Build
by Evgeny_Crimea » Mon Aug 06, 2012 5:48 pm
MattyZee wrote:I will eventually post it here once i finalise my Z axis design.
Hello. Please share your drawings. I want to build such a machine, and a profile in the Ukraine, no!
- Evgeny_Crimea
- Posts: 1
- Joined: Sun Aug 05, 2012 10:55 am
13 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 38 guests