orcinus wrote:I'm just not sure how to route the cables - i've had them soldered 90 deg. on my display, the pin headers on the ViKi are straight. I might unsolder them and solder in 90 deg ones...
Wired1 wrote:I have the Viki running on an Azteeg X3 with marlin firmware and it all works fine on the test bench including printing from the SD card with the standard cables it came with. I have an early Azteeg X3 on another printer and it initially had some issues with interference on the serial line causing Pronterface to drop out so there may be problems with the unshielded leads for the Viki display when I get it installed on the printer depending on where I mount the panel and controller on the printer.
SystemsGuy wrote:I think Roy's a victim of his own success. Take a look at this thread, I have mine hooked up and working with my X3. Do note that you will need to disable the SD slot on teh X3 to use the one on the ViKi.
https://groups.google.com/forum/#!searc ... tGwtHNU0AJ
Roy has finally posed X3 1.1 wiring diagrams on his site, so that's progress!
Users browsing this forum: No registered users and 14 guests