Metal Parts for Laser 2.X (.dxf files)

[rsm5178]

Hey Laser Community,

In case anyone would like to source their own plates, here are the flat plate layouts for the laser 2.x that I made from the model a few years back.

*****IMPORTANT******It is very important to use 5052 grade aluminum for the plates with bends. The flat plates can be 6061 grade. All plates are 1/8" thick in design.

I preferred to water jet the ones I made, but a laser should also work the same.

You will also need:

1. PEMS (I used selfclinchdirect.com which can be pricey in small quantities due to shipping)
2x----TR-SOS-440-12
3x----TR-CLS-632-2
4x----TR-AC-0420-2

2. Way to bend the plates (brake press is preferred)

3. Way to press in the PEMS (hydraulic press is preferred)

Thanks,

Rich