Bill's 2.x Gallery
Posted: Mon Jun 13, 2011 4:43 pm
I will post my many projects here along with my setting used to complete them. I am currently using Bart's 2.x laser along with Lightobject's DSP controller.
Here is my first plaque to say thanks to the two people that have helped make my dream of owning a laser possible.
Material: $ .97 cheap plywood plaque blank from Walmart
Laser Settings: Speed 150mm sec | Power: 20% | Scan Gap: .09
This plaque was not finished in any way. There was some minor smoke residue around the letters but that was removed with a DA sander. I already have 2 jobs lined up to make award plaques for a 5K race and a Triathlon. I have found some finished plaque blanks on Ebay and plan to use these to start out with until I can find a stable supplier with reasonable pricing.
Bill
Here is my first plaque to say thanks to the two people that have helped make my dream of owning a laser possible.
Material: $ .97 cheap plywood plaque blank from Walmart
Laser Settings: Speed 150mm sec | Power: 20% | Scan Gap: .09
This plaque was not finished in any way. There was some minor smoke residue around the letters but that was removed with a DA sander. I already have 2 jobs lined up to make award plaques for a 5K race and a Triathlon. I have found some finished plaque blanks on Ebay and plan to use these to start out with until I can find a stable supplier with reasonable pricing.
Bill