BenJackson wrote:Unfortunately the DXF doesn't put the cutout on a different layer, but luckily it is a continuous profile that can easily be selected by itself.
Here I did two versions. The only difference is that I nearly cut through with my "scoring" marks (you can see pinholes of light through the piece whereever two of the marking lines intersect). Even the one on the right (where you can see the lines look "lighter" and there's less discoloration) I could have used even less power. They're sitting on a scrap of the same plywood so you can judge the level of discoloration.
educa wrote:Dirk, these babies look very nice. I do indeed see the coloration onthe front but somehow that doesn't look that bad since it gives even more 3d effect. are these 2 dragons cut with ppi? The contour looks very nice, but quite dark. the inner carvings seem quite deep, maybe this could be set a lot lighter with some ppi changes? It does all by all look quite good and I suppose your laser will also have cut this reasonably fast?
Users browsing this forum: No registered users and 1 guest