PEM Nuts Installation

Questions, Suggestions, Tips, Etc

PEM Nuts Installation

Postby techsavvy34 » Sun Jun 22, 2014 6:30 am

I'm wondering how you install the pem nuts on the laser carriage and the z lift plates? Can it be done with hand tools or a bench vise?
techsavvy34
 
Posts: 20
Joined: Sun May 18, 2014 9:52 pm

Re: PEM Nuts Installation

Postby greenvandan » Sun Jun 22, 2014 2:21 pm

I would go with bench vise, even better an arbor press if you have access to one.
greenvandan
 
Posts: 59
Joined: Mon May 28, 2012 1:41 am
Location: Baltimore, MD

Re: PEM Nuts Installation

Postby rsm5178 » Tue Jun 24, 2014 3:41 pm

make sure you do not crush the floating PEM. I used a smaller socket to press on the actual nut.
rsm5178
 
Posts: 119
Joined: Tue Jul 23, 2013 9:57 pm
Location: 19425

Re: PEM Nuts Installation

Postby ww_kayak » Fri Feb 06, 2015 6:47 pm

Are the PEM nuts really necessary with 1/8" 6061? Or is this just a way to avoid tapping?
ww_kayak
 
Posts: 3
Joined: Wed Jan 28, 2015 2:02 am

Re: PEM Nuts Installation

Postby reeser » Fri Feb 06, 2015 8:33 pm

I think the nuts are necessary. The idea is that they "float" in their housing. I think this is designed to eliminate possible binding by allowing the nuts to move a little bit.
As a previous poster suggests , a socket over the nut is needed to keep from crushing the housing. I used an arbor press, which probably gives a little more control than a vise, although a vise would probably work.

Dick
reeser
 
Posts: 37
Joined: Mon Dec 22, 2014 3:08 am

Re: PEM Nuts Installation

Postby rsm5178 » Mon Feb 09, 2015 3:12 am

You surely want the PEM nuts.

First, you want at least 3 threads engagement. Second you don't want steel on aluminum contact (especially for the z axis). Third, you want the planar and angular tolerance relief as reeser mentioned.

Rich
rsm5178
 
Posts: 119
Joined: Tue Jul 23, 2013 9:57 pm
Location: 19425

Re: PEM Nuts Installation

Postby ww_kayak » Mon Feb 09, 2015 3:34 am

Makes sense, Thanks
ww_kayak
 
Posts: 3
Joined: Wed Jan 28, 2015 2:02 am

Re: PEM Nuts Installation

Postby Gennyswiss » Tue Feb 12, 2019 4:46 am

I have installed this in my Windows laptop but now when I am trying to install it in my MacBook Pro, it is showing some error messages of the iTunes Error code 590624. Is it any fault in my device or error in the version of the software that I have downloaded.
Gennyswiss
 
Posts: 1
Joined: Mon Feb 11, 2019 6:35 am


Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 2 guests

cron