JakeS wrote:I'm looking to import the config file from the ZIP attachment. When I unzip it, the file I get is "300x150 FL.PMPrs"
In the LaserCAD software it is looking for a .cf5 file extension. Should I just rename the extension or do I have the wrong file?
Thanks! (So close!!)
Jake
twehr wrote:JakeS wrote:I'm looking to import the config file from the ZIP attachment. When I unzip it, the file I get is "300x150 FL.PMPrs"
In the LaserCAD software it is looking for a .cf5 file extension. Should I just rename the extension or do I have the wrong file?
Thanks! (So close!!)
Jake
The cf5 file is not valid for the current version of the controller. Tat was part of the instructions I wrote for an earlier version.
Users browsing this forum: No registered users and 10 guests