#10 Washer Now Black

Questions, Suggestions, Tips, Etc

#10 Washer Now Black

Postby bdring » Wed Jul 06, 2011 3:27 am

minor change...

I changed the #10 flat washers that are used all over the place including holding the skins to steel with black oxide. I think it looks a lot better on the skins and the new washer is a more consistent thickness. Some I were getting were very thin and could cause problems with bottoming screw in the extrusions. I think some people switched to black oxide themselves anyway.
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 16 guests

cron