Maker slide adjustment
2 posts
• Page 1 of 1
Maker slide adjustment
by cozmicray » Sun Oct 07, 2012 8:19 pm
Is there a site out there that addresses the adjustment of a makerslide?
How much drag on wheels, how much slop in bearings?
I have a couple on a OrdBot Hadron.
Why is it so difficult to get Makerslide parts and extrusions?
I believe it has been out since Mar 2012.
Any website about Makerslide I have visited are TERRIBLE!
Tnx
How much drag on wheels, how much slop in bearings?
I have a couple on a OrdBot Hadron.
Why is it so difficult to get Makerslide parts and extrusions?
I believe it has been out since Mar 2012.
Any website about Makerslide I have visited are TERRIBLE!
Tnx
- cozmicray
- Posts: 168
- Joined: Thu Sep 20, 2012 4:32 pm
- Location: Blue Bell, PA
Re: Maker slide adjustment
by bdring » Sun Oct 07, 2012 9:00 pm
Makerslide is available at Inventables.com
Install the wheels at the widest setting. When placed on the Makerslide rail the wheels will probably be loose. Adjust the eccentric nut until the wheels touch the rails. Do not over tighten the wheels or you may put a flat spot on them.
Install the wheels at the widest setting. When placed on the Makerslide rail the wheels will probably be loose. Adjust the eccentric nut until the wheels touch the rails. Do not over tighten the wheels or you may put a flat spot on them.
Bart
"If you didn't build it, you will never own it."
"If you didn't build it, you will never own it."
- bdring
- Site Admin
- Posts: 2966
- Joined: Sun Nov 22, 2009 7:33 pm
- Location: Chicago, IL, USA
2 posts
• Page 1 of 1
Return to MakerSlide General Discussion
Who is online
Users browsing this forum: No registered users and 1 guest