The easiest(?) way to tap MakerSlide

General questions and comments.

The easiest(?) way to tap MakerSlide

Postby JuKu » Mon Sep 09, 2013 12:29 pm

FYI: Misumi self-tapping screw HTJ5 is compatible with MakerSlide. In other words, this worked for me:

Standard torx25 bit in power screwdriver, held MakerSlide firmly. Pressing hard to the tabletop with one hand is enough, I didn't need a vice (but I'm a big guy, YMMV). Screw the bolt as far as it goes, back up if needed, repeat. First or second time it will go all the way in. Take bolt out, insert plate and washer (or whatever you are attaching to the end) and screw it back. Done.
JuKu
 
Posts: 1
Joined: Mon Sep 09, 2013 8:23 am

Return to MakerSlide General Discussion

Who is online

Users browsing this forum: No registered users and 9 guests

cron