Adjustable Bottle Neck Adapter (rotational unit)

Discuss ideas and construction techniques here.

Adjustable Bottle Neck Adapter (rotational unit)

Postby Techgraphix » Sat Sep 08, 2012 9:27 am

Using the Buildlog-rotational-unit i found it difficult to place a bottle horizontal. The neck was to thin to adjust the idlerwheels so that the bottle was horizontal. I noticed most bottlenecks where between 25 and 30mm round.
This ABNA (Adjustable Bottle Neck Adapter) can be centred around 25 to 30mm bottlenecks and make the diameter 70mm.
Aligning the bottle is very easy now.
ABNA1.jpg
Detail while operative

ABNA2.jpg
Use with Rotational unit

ABNA3.jpg
30mm round

ABNA4.jpg
25mm round

ABNA5.jpg
Parts

ABNA6.jpg
Around smaller bottleneck topview


Kees
Techgraphix
 
Posts: 122
Joined: Fri Feb 24, 2012 8:37 pm
Location: Appelscha, NL

Re: Adjustable Bottle Neck Adapter (rotational unit)

Postby greenvandan » Sat Sep 08, 2012 1:37 pm

Nice work! Simple and effective with a good acronym to boot.
greenvandan
 
Posts: 59
Joined: Mon May 28, 2012 1:41 am
Location: Baltimore, MD

Re: Adjustable Bottle Neck Adapter (rotational unit)

Postby zachjowi » Thu Jun 20, 2013 4:34 pm

very cool! Where did you find the drawings/files for the plastic parts of the rotational unit?
zachjowi
 
Posts: 27
Joined: Tue May 07, 2013 1:13 pm

Re: Adjustable Bottle Neck Adapter (rotational unit)

Postby bloq » Fri Dec 11, 2015 7:48 am

awesome! just found this older thread. Do you like to share the files? This would be great ...
bloq
 
Posts: 88
Joined: Mon Dec 29, 2014 9:15 am

Re: Adjustable Bottle Neck Adapter (rotational unit)

Postby Techgraphix » Fri Dec 11, 2015 12:13 pm

No problem to share the files but i do it in ArtCam, If you use that too i can send you that file too..
I included the vectors in EPS-format in a ZIP.. you have to make your own toolpaths and adjust the depths to your material size..
I used 2mm thick carbon-epoxy for the wheel, the clamps(sliders) are 15mm thick and the block was made from 25mm POM
Some of the allenscrews need to be turned off a bit to fit in the wheel's slot.
Attachments
ABNA.zip
(10.88 KiB) Downloaded 3277 times
Techgraphix
 
Posts: 122
Joined: Fri Feb 24, 2012 8:37 pm
Location: Appelscha, NL


Return to Designs and Design Ideas

Who is online

Users browsing this forum: No registered users and 1 guest

cron