20x20mm extrusion & Makerslide...
Posted: Sun Jul 28, 2013 8:31 am
This is a corner bracket to join 20x20mm extrusion and Makerslide:
http://www.thingiverse.com/thing:124562
http://www.thingiverse.com/thing:124562
Building CNC Machines - Laser/Routers/Etc.
https://buildlog.net/forum/
TLHarrell wrote:Looks perfectly fine for joining the two pieces together, but I'm concerned about shear support. Doesn't look like it'd stand up to much of a push if you were to tilt the 20x20 to the upper left of your photo, 45 degrees in the direction of the angle on your base plate. The back corner of the 20x20 where it contacts the Makerslide (lower right corner of your photo) would separate rather easily.