Re: DSP Commercial Controller Support
Posted: Fri Jan 27, 2012 11:34 am
Hello all ,
I have just been able to get my laser engraver going on, its able to engrave
i had a few question which I thought I would ask before I start experimenting,
I am loosing a few steps for teh steppers in the followwing conditions
1. after the machine home's to the limit switches it tries to come back to the origin when I loose steps because it try's to fly there at high accln.
2. when i start a job it tries to fly fast to the start position where the stepper motors looses its steps.
In both cases I am unable to find the setting on teh software where I can modify these,
anyone who's knows what to be done - kindly post back.
regards
Irfan
I have just been able to get my laser engraver going on, its able to engrave
i had a few question which I thought I would ask before I start experimenting,
I am loosing a few steps for teh steppers in the followwing conditions
1. after the machine home's to the limit switches it tries to come back to the origin when I loose steps because it try's to fly there at high accln.
2. when i start a job it tries to fly fast to the start position where the stepper motors looses its steps.
In both cases I am unable to find the setting on teh software where I can modify these,
anyone who's knows what to be done - kindly post back.
regards
Irfan