Page 16 of 22

Re: Announcing the ORDuino !

PostPosted: Sat Apr 28, 2012 11:34 pm
by tango282


Hmmm not sure why 80's movies keep popping into my head after I read your comments.........best just to go with it :?

There's little piles of PLA 'poop' all over my desk!

PostPosted: Sun Apr 29, 2012 12:10 am
by frob
..Never thought i could be so happy to say that!
Extruder control 100% functional...
... Now to rebuild this mess of parts as a functional printer....
"we have the technology" :D

There's little piles of PLA 'poop' all over my desk!

PostPosted: Sun Apr 29, 2012 12:12 am
by frob
tango282 wrote:
Hmmm not sure why 80's movies keep popping into my head after I read your comments.........best just to go with it :?


Lol!! i remember that clip, too bad it wont play for me right now, that was the funniest part of that movie :lol: Utoob is too busy it seems. :roll:
i'll try again later

There's little piles of PLA 'poop' all over my desk!

PostPosted: Sun Apr 29, 2012 12:27 am
by frob
orcinus wrote:Stupid question: you didn't leave a reset pin floating somewhere and all the grounds are connected, right?
Lol, well i have been known be distracted enough for that sort of thing to slip by me, but not it a long time, and not in this case.
Its probably related to the fact that the USB IC is set up as self-powered from the USB cable, while the rest of the board has its own separate 5V supply. they're interconnected by a 500mA PTC, but i didn't have it mounted before, for PSU testing purposes. Problem seems to have gone away since i installed it.

Re: Announcing the ORDuino !

PostPosted: Sun Apr 29, 2012 12:52 am
by orcinus
Sorry, had to ask :)
It's always something stupid like that, at least in my case :lol:

Re: Announcing the ORDuino !

PostPosted: Mon May 14, 2012 4:18 pm
by aleith
Looking for shipping status update on the orduino and build plate?

Re: Announcing the ORDuino !

PostPosted: Mon May 14, 2012 4:29 pm
by canadianavenger
I'm still waiting for an answer on the watchdog ;)

Re: Announcing the ORDuino !

PostPosted: Mon May 14, 2012 6:53 pm
by orcinus
Image

No watchdog for you! Come back, one year!

Re: Announcing the ORDuino !

PostPosted: Tue May 15, 2012 8:54 pm
by aleith
that is not making me feel warm and fuzzy Are you implying Frantz has absconded with my money to the strip clubs on Catherine St. :x

Build plates on their way from China...

PostPosted: Sun May 20, 2012 11:29 pm
by frob
.. So hopefully here midweek, so starting to ship those out by before the end of next week.
ORDuino's should follow very quickly after that.

aleith wrote:Looking for shipping status update on the orduino and build plate?