Enraged wrote:If you use binder clips, you can take the glass off, which makes it easier to print many parts in a row (just swap to a blank sheet).
Enraged wrote:Also, I got 4 sheets of 8.5" x 8.5" glass from a local glass shop for $10.
RSWeaverAz wrote:@Frob
Hadron sized Lava arrived Monday 6/25.
A small gouge in the box, but packed well so all is ok.
On the Hadron itself, so far I've only built the Gantry,
getting ready to drill the holes in extrusion's for the wiring.
Things should go quickly then ...
BTW, did you get a message from me at your http://www.sotadesign.ca/
about the Sota-Spindle, it will be some time before I need one, possibly for the ShapeOko.
But was looking for some info ...
Rich
Users browsing this forum: No registered users and 38 guests