by evil2002usna » Sun Nov 10, 2013 4:45 am
I always have surface lines in my print surface that resembe gaps. Does anyone know what these lines are usually caused from. I am using and ezstruder with a j-head 1.75mm PLA filament direct drive. I think the problem could be stemming from lack of extrusion force from the ezstruder, but I have seen people with ezstruders that have good print quality. I have messed with extrusion temperature from 200 up to 230 with varying results but usually some level of lines always returns. I ordered a new extruder a week ago that should resolve and extrusion force issues I might have, but I wanted to see if anyone had any experience with this.
- Attachments
-