Page 3 of 3
Re: Ordbot recommissioned
Posted:
Sun May 10, 2015 6:37 pmby WillAdams
And when I finally got around to patiently considering all the possibilties I found that the Y-axis motor pulley didn't have a set screw.
Okay, had a spare 18 tooth pulley so used that (for some reason the set screw from the latter wouldn't fit). I'm thinking that if I have to have a mis-match, it's beter to have the lower count pulley on the Y-axis for more torque --- is that reasonable?
Re: Ordbot recommissioned
Posted:
Mon May 11, 2015 10:29 pmby madmike8
I might have missed it somewhere, but are you running MXL or GT2 belts/pulleys.
I just swapped over to GT2, and I'll Mail you my old MXL pulleys if you need them.
Re: Ordbot recommissioned
Posted:
Sat May 16, 2015 5:23 pmby WillAdams
Thanks!
Using MXL but planning to switch to GT2 eventually, fortunately had a spare.
Re: Ordbot recommissioned
Posted:
Sun May 17, 2015 6:15 amby madmike8
If you want them, just PM your address and I'll drop them in the mail next time I'm near the post office.
Re: Ordbot recommissioned
Posted:
Tue Aug 16, 2016 10:28 amby WillAdams
Well, haven't switched to GT2 yet, but have switched to a V2 Azteeg X5 mini paired w/a V2 Viki LCD.
Nice, and very convenient, esp. w/ using a tablet w/ a micro SD card.
Need to puzzle out why I can't control the fan on pin 2.4 and print a case for the LCD then it'll be time for a full tear down and rebuild.