Ordbot Spares

[grezmel]

Hi, can anyone tell me where I can get spares from, specifically part number B17061 - Z lift blocks

Thanks Graham

[rsm5178]

I just hand drilled 3/8th inch cutting board and put these (see link) under it to add support and set the height.

( http://www.automationtechnologiesinc.co ... -and-right)

You could jut print them and get something good enough to work.

Rich

[grezmel]

Thanks for your help. Isn't it possible to get original Ordbot spares ?

[madmike8]

Get the anti wobble kit... you'll be happier...

There are some printable versions of the blocks out there too...

[grezmel]

Where do I buy the anti wobble kit from?

[madmike8]

rsm5178 linked it above.


Here...
http://www.automationtechnologiesinc.com/products-page/3d-printer-machine-parts/z-lift-plate-left-and-right

or here...

http://www.ebay.com.sg/itm/3D-Printer-ORD-Bot-HadronZ-Lift-Plate-Left-and-Right-parts-/181567297952?pt=LH_DefaultDomain_0&hash=item2a464119a0

I'm redoing my Ordbot now, and will be reprinting the blocks needed with this.

http://www.thingiverse.com/thing:42260

PM your address and I'll mail you a couple if you don't have the ability to get them yourself.