That will work in theory but i haven't tested it yet; the 5V setup is a little special and it requires additional surgery on the boardRSWeaverAz wrote: 5 volt for the ORDuino ( will that work ?) 12 volt for steppers, extruder, & HBP
Possibly, i was just discussing some clever but fairly simple firmware improvements that could be made to allow that much more easily.So I guess set the LAVA HBP up to the 12 Volt 100 Watt (8.5 Amp) config,
that way about 3.5 amps are left for the steppers and extruder ... but is that enough?
20W is pretty typical for extruder heaters, I've been looking around myself and it seems everyone is using the same value resistor pretty much.I did a quick check and found someone who claimed only 20 Watts while warming up their Rep-Rap extruder heater,
and about 3 watts to extrude with a .5 mm nozzle @16 mm/S filament feed (using a well insulated hot end ... whatever that means).
frob wrote:Today!
Most shipped already, last few going out this morning ... individual emails to that effect going out a bit later today.
dalewheat wrote:Frantz,
Are you shipping bot the "Hadron" and "Quantum" sized heated build platforms? Or just the "Hadron" size?
I'm really looking forward to both of them. My CD jewel-case cover has been retired, after teaching me the valuable lesson of the need for a perfectly flat build platform.
Thanks!
Dale
frob wrote:Hi Dale,
we shipped 'em all, Hadrons and Quantums -
...
Users browsing this forum: No registered users and 22 guests