Enraged wrote:So I finally got around to connecting my Lava heated bed, but no LEDs are lighting up. Suggestions?
Hi Enraged, please PM me so we can try to debug this, if the info below doesnt do it ...
All LAVA's were fully tested before they shipped, so we know the LED's work, they're not installed backwards.
Can you check the voltage at the terminals ? the LED's need at least 10.5 to 11V before they turn on.
There is also a small 2-pin 2mm header + shunt installed on the bottom side where the FFC cable connector would go, this is to enable the LED's when the FFC is not used. if the shunt is missing, that would explain the LED's not working.