What are you making with your laser?
3 posts
• Page 1 of 1
What are you making with your laser?
by bdring » Fri Nov 30, 2012 2:07 am
Tiny grip tape snowflakes. Is there any other way to cut grip tape?
The edge looks a little rough because it is sticky and picks up bits. It cleans up with a wipe of the finger.
The edge looks a little rough because it is sticky and picks up bits. It cleans up with a wipe of the finger.
Bart
"If you didn't build it, you will never own it."
"If you didn't build it, you will never own it."
- bdring
- Site Admin
- Posts: 2966
- Joined: Sun Nov 22, 2009 7:33 pm
- Location: Chicago, IL, USA
Re: What are you making with your laser?
by Gadroc » Fri Nov 30, 2012 4:40 am
I make parts and panels for my flight simulation cockpit which is a replica A-10C.
- Gadroc
- Posts: 77
- Joined: Thu Nov 10, 2011 8:18 pm
Re: What are you making with your laser?
by twehr » Fri Nov 30, 2012 5:27 pm
This is a faceplate for my new CNC router speed controller.
tim
--
"The answer is usually easy and obvious once you know what it is." tw
DIYLaser Blog
SemiHomemadeTools.com
--
"The answer is usually easy and obvious once you know what it is." tw
DIYLaser Blog
SemiHomemadeTools.com
- twehr
- Posts: 439
- Joined: Mon May 24, 2010 4:49 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests