DSP Commercial Controller Support

Discussions and help on this commercial controller.

Moderator: twehr

Re: DSP Commercial Controller Support

Postby lasersafe1 » Tue Jan 29, 2013 3:24 pm

That's why its called "support". Can you do us a favor? You changed two things at once to fix the problem. Can you back out and tell us if it was one or the other? I suspect it was the falling edge problem, but since you also changed acceleration, I don't know for sure.
lasersafe1
 
Posts: 599
Joined: Fri Nov 27, 2009 8:23 pm

Re: DSP Commercial Controller Support

Postby jkarpy » Wed Jan 30, 2013 2:51 am

lasersafe1 wrote:That's why its called "support". Can you do us a favor? You changed two things at once to fix the problem. Can you back out and tell us if it was one or the other? I suspect it was the falling edge problem, but since you also changed acceleration, I don't know for sure.

I will back up to my previous settings and test when I am running that same sheet tomorrow. I will post my results.
jkarpy
 
Posts: 10
Joined: Thu Apr 19, 2012 6:06 pm
Location: Orlando

Previous

Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 0 guests

cron