Timing belt clamps

Bearings/Motors/Belts/Gears/Etc.

Timing belt clamps

Postby buildsomething » Fri Feb 12, 2010 8:10 pm

Here is the way that I am clamping two open ends of a timing belt used to drive the X and Y axis.
It uses a scrap piece of belt that is clamped / squeezed between a machined block. The scrap piece engages the two ends and then through shear friction due to clamping the whole thing stays together. The key here is make sure that the gap that the belts and the scrap piece are in are about .010 to .020" less that that the total overall thickness of the two. Once clamped you cannot pull them apart.

Overall tension adjustment to the belt is done by a idler pulley located at one end of the system. The other end of course is the driver.

This solution is cheap and quite robust.

Richard
Attachments
Clamp 1.jpg
Clamp.jpg
buildsomething
 
Posts: 69
Joined: Tue Jan 05, 2010 12:54 am
Location: Toronto, Ont

Return to Mechatronics

Who is online

Users browsing this forum: No registered users and 1 guest