Grounding the Frame

Issues related to safety

Grounding the Frame

Postby dirktheeng » Sun Aug 14, 2011 7:57 pm

All,

I was just finishing up the wiring for the rig and thought I would try to ground the frame for safety (shock hazard). However, to my surprise some of the members on my frame did not have a path to ground. The aluminum is annodized and that layer is a good insulator. If your frame nuts don't penetrate this layer there won't be a path to ground. I reccommend checking the resistance to all your frame members. Either find a spot to poke through the finish layer or touch your probe to the cut end. Also, you should check the actual resistance to make sure it is a good connection... don't just use the short/open probe as this can be a little deceptive if you have a weak connection.
dirktheeng
 
Posts: 616
Joined: Thu Sep 09, 2010 4:49 pm

Re: Grounding the Frame

Postby utfifas09 » Wed Jan 28, 2015 1:34 am

All of us perform think about start in order to perform.
utfifas09
 
Posts: 2
Joined: Tue Jan 27, 2015 2:11 am


Return to Safety

Who is online

Users browsing this forum: No registered users and 0 guests